Features

• Mechanically actuated diapharagm
• High precision balls and seal rings for accuracy.
• Manual flow control, adjustable through stroke length adjustable knob.
• Composite GYLON/PTFE Hypalon diapharagm for long life
• Motor driven worm shaft & Worm wheel drive.
• Liquid end material of construction in PP (Also in SS316, PVC and Teflon on request)
• Light weight aluminium alloy body
• Modular design occupying less foot print
• Steady state accuracy +/-2%
• Repeatability +/-3%
• Turn down ratio 10:1

Installation & Operation

• Fix the pump securely in a safe location away from sunlight, sources of heat and other dangerous environs, allowing for a maximum suction lift of 1 metre only.
• Cut the supplied tubing into a 1 metre section and connect one of its ends to the suction of the pump and other to the foot value.
• Ensure the suction tubing is held straight within the chemical storage tank.
• Connect the rest of the required length of tubing to the discharge side of the pump head.
• Connect the NRV in a vertical position in the required injection point
• Position the discharge tube above the pump head in a safe direction
• Plug in the mains chord of the pump to a single phase 230vAc, 5amp socket.
• Wait for the pump to prime into the head.
• As soon as the liquid starts to flow out of the tube turn off the pump promptly now connect the fully primed tube into the NRV.
• Turn the pump on again and check for leaks in all areas.
• Now finally adjust the speed buttons as per your dosing requirement.

Specifications